Leaderboard

Looks great so far On the fuel tank you'll see three fittings close to the frame on top of the tank that is where the fuel pickup and returns would have gone the larger circle out towards the outside of the tank was just the fuel sending units for the gas gauge and would have had two wires connected to ita ground wire under one of the out circle retaining bolts and a signal wire to the center of the sending units. I didn't get into all the air lines and wiring as you have .but as I spent the last five years of my career as a heavy equipment mechanic I did try to connect as many hydraulic lines as I could . The kit has almost enough hydraulic line to do everything except the over head line front to rear which I did with craft wire ( If l had it to do again I'd have used solder for those instead. I also drilled the tailgate latches and used craft wire to hide them so the tail gate could be opened. I also added the winch cable and snatch block as shown on old purple As you can see I weathered this one up as a fifty year old heavily used unit ( maybe a bit over done) and will be suspended towing it with my already completed AMT Pete tow truck.

Wish you the best in getting through it all.

Wow, thoughts with you