Casey Posted September 6, 2015 Anyone care to share a method for making rivets? Share this post Link to post Share on other sites
0 ransomeli Posted September 8, 2015 (edited) I have used HO and O model railroad rivets depending on what size was needed. drill small holes where needed and glue in place. Very time consuming but they look better than the molded on rivets from the kits. I thought they looked more "realistic" than the pounce wheel method of replacing rivet detail. Edited September 8, 2015 by ransomeli Share this post Link to post Share on other sites
0 b-lever Posted September 5, 2016 http://www.archertransfers.com/SurfaceDetailsMain.html These will work decal with rivit detail Share this post Link to post Share on other sites
0 b-lever Posted September 5, 2016 AR88016 and AR88009 These both have a good number of different sizes on the sheets Share this post Link to post Share on other sites
0 Casey Posted September 6, 2016 Thanks for sharing. Someone told me about those a while back but I forgot the name. Which do you recommend for cabs/sleepers? --Casey 1 Share this post Link to post Share on other sites
0 b-lever Posted September 6, 2016 Both set about 20 bucks a piece the 016 have lots that can be used just depends on the spacing of them 1 Share this post Link to post Share on other sites
0 Casey Posted September 6, 2016 34 minutes ago, b-lever said: Both set about 20 bucks a piece the 016 have lots that can be used just depends on the spacing of them Just ordered some. Thanks again! Share this post Link to post Share on other sites
0 dsldriver Posted September 14, 2018 Great article about rivet detail in the new issue of Classic Truck Modeler magazine! Share this post Link to post Share on other sites
Anyone care to share a method for making rivets?
Share this post
Link to post
Share on other sites