41CHEVY Posted May 5, 2017 With all the new tech put on newer semi's the one thing missing that is most visible on a model is the GPS saucer. Less than a 1/2 hour I made up a half dozen for my Mobius International buils. .I use the dish shaped plastic seal from the 1/2 gallon juice containers, either 5 minute epoxy or the stick epoxy. The 5 minute gives less air voids. After it cures I sand the bottom flat and glue a 015 plastic disc to the bottom with CA glue. Sand the sides flat and take a piece of square tubing cut at a 45 degree and glue to botton to make the cab mount. Here is a photo how to. Thanks for looking. Paul All mounted up with the cable run under the cab. Share this post Link to post Share on other sites
Casey Posted May 6, 2017 Awesome. Thanks for sharing! Share this post Link to post Share on other sites
BuddyT Posted June 22 Here is a photo how to. I can't get thew photos to open. Could you repost them. Thanks. Share this post Link to post Share on other sites
