41CHEVY Posted November 10, 2018 (edited) Making an E10 1425 c.i. twin turbo MACK V12 from a pair of AMT Mack V8's. Here is the progress so far. Paul Hosted on FotkiHosted on FotkiHosted on FotkiHosted on FotkiHosted on Fotki Edited November 16, 2018 by 41CHEVY Share this post Link to post Share on other sites
Plybeep68 Posted November 10, 2018 Looking good ! What kind of putty do you use ? Share this post Link to post Share on other sites
plastic trucker Posted November 10, 2018 Nice start. Share this post Link to post Share on other sites
41CHEVY Posted November 11, 2018 16 hours ago, Plybeep68 said: Looking good ! What kind of putty do you use ? That is Squadron White putty. I like it because it dries quick , sands easily and so far no shrinkage. Share this post Link to post Share on other sites
41CHEVY Posted November 16, 2018 Got a major part of the fitting done. Had to add 3/16" into the injector pump and split the intakes into 3 pieces to add fillers to lengthen them. Still need to blend in the added intake runners. Made 5 pieces to lengthen the exhaust manifolds and make pipes to feed the turbo. Modified a 6 cylinder oil pan to fit the engine too. All the holes are drilled for the injector lines, fuel system, compressor air and coolant lines and Turbo lube and drain line. Paul Hosted on FotkiHosted on FotkiHosted on FotkiHosted on Fotki Share this post Link to post Share on other sites